关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:一种改进的永磁电机无差拍预测控制方法
作者:周露, 刘刚, A. Houari, 等
2017年第9期 访问次数:246次

摘要:为解决数字控制方式固有的延时和开关非线性问题,提升电流环性能,本文基于永磁同步电机离散化数学模型,提出一种同时引入延时补偿和死区补偿改进无差拍电流预测的控制方法。在一个周期内,实现双步计算来补偿延时作用,并考虑逆变器开关的非线性及死区时间引起该周期内电压的变化进行电压补偿。相较于基本的预测方法,改进方法能够有效地提升动态响应和稳态精度,降低参数敏感性。
关键词:永磁同步电机;无差拍电流控制;延时补偿;电压补偿
Abstract: To solve the delay and inverter nonlinearity problems in the digital control system and increase the currentloop performances, basing on the discrete mathematic model of PMSM, this paper proposed an improved deadbeat predictive control method introducing delay compensation and voltage compensation at the same time. In one cycle, realize two steps calculation to compensate delay, and then considering voltage change causing by the nonlinearity and deadtime of inverter to compensate the voltage. Comparing to the basic predictive method, this improved method could promote the dynamic response and steadystate accuracy, reduce the parameter sensitivity.
Key words: permanent synchronous machine; deadbeat control; delay compensation; voltage compensation

 

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码